To indicate a right turn, either of the following would be appropriate: (a) hand or arms extended upward from the left side of the vehicle (b) activation of front and rear turn signals on the right side of the vehicle.To indicate a left turn, either of the following would be appropriate: (a) hand or arm extended horizontally from the left side of the vehicle (b) activation of front and rear turn signal lights on the left side of the vehicle.Appropriate Signals for Stopping, Turning, Changing lanes, and Decelerating:
Unlawful use of lights to Signal for PassingĪ driver commits the offense of unlawful use of lights to signal for passing if the driver flashes any lights as a courtesy or does a pass signal to other drivers who are approaching from the rear. That is because hand-and-arm signals do not provide enough of a warning any time that you are driving a wide or long vehicle. At night-or when visibility is poor-you must use turn signal lights, not hand-and-arm signals.
Use hand and arm signals only in daylight hours when you need them and can clearly see people and vehicles at a distance of 1,000-feet. The times of day and weather conditions are also important issues with regard to your decision as to whether or not to use hand-and-arm signals. Your stop lights will alert other drivers behind you, and signal them that you are slowing down. You should also signal before you slow down or stop. When you are parked at a curb and about to re-enter traffic, then use a signal long enough to alert oncoming traffic that you are that you are moving into a traffic lane. If your vehicle is moving in traffic, for example, then use your signal at least 100-feet before making a turn or lane change. Check ahead, behind, and to the side in all of these situations. Before making such a move, be sure that you can do so safely. It makes clear that you must always signal before you turn, change lanes, move to the right or left, or pull away from the curb. In general, the DMV’s publication–the Oregon Driver Manual-sets out the basic concepts. In this section, we shall address all of these issues. Proper signals include turn lights or, under certain circumstances, hand and arm signals. Replace hand to appropriate position on steering wheel before braking, gear selection or steering.īrake lights are a signal that can be kept on (especially at night) and it is not necessary to cancel these after the vehicle has been brought to a complete standstill.The statutes for use of appropriate signals for stopping, turning, changing lanes, or suddenly decelerating a motor vehicle are set forth in ORS 811.390 – ORS811.405. Extend right arm sidewards from shoulder with forearm vertical and upward and with palm of hand to the front.Ĥ. HAND SIGNAL - TO STOP OR FOR SUDDEN REDUCTION OF SPEEDĢ. Replace hand to appropriate position on steering wheel before braking, gear selection or steering. Move forearm in a circular anti-clockwise motion.Ĩ. Turn forearm in a vertical and downward position from elbow.Ħ. Extend right arm sidewards from shoulder.ĥ. Check rear-view mirror(s) and blind spot to the left.Ĥ. Only two attempts shall be permissible, however, if not successful at the 2nd attempt penalty points shall again be allocated and the test continued.ġ. If not carried out satisfactorily the first time, the applicant shall be requested to attempt to execute this signal once more. The applicant shall not be requested to repeat this signal if carried out satisfactorily the first time. This signal shall be used in conjunction with direction indicators, which shall be activated prior to the hand signal. This signal shall be given in good time and for sufficient duration prior to braking, gear selection or steering. Retract arm in good time before braking and/or gear selection and before negotiating the turn.Ħ. Extend right arm horizontally from shoulder with palm of hand to the front.ĥ. Signal intention using direction indicators.Ĥ. Check rear-view mirror(s) and blind spot to the right.Ģ. SIGNALLING - HAND SIGNALS HAND SIGNAL - TO TURN RIGHTġ.
0 kommentar(er)
